Development of Arduino Fingerprint Attendance System with Cloud Data Storage

Activity : Submitting the draft of FYP 1 report to the supervisor. Objective : To ensure and help student finish FYP 1 report before the deadline. Content/Procedure :  1) Student need to finish up the report based on supervisor expectation. 2) Student need to submit the draft before 25 October 2019. Result/Analysis : 1) All important task or subtopic are included inside the report. Student print the report and send it to supervisor as a draft. 2) Student manage to make Gantt chart and schematic diagram for the project as shown in Figures below. Gantt chart is important for the student time management and planning in order to complete the project. Meanwhile schematic diagram is important for the circuit configuration and connection of the project.  FYP 1 Gantt Chart Schematic Diagram of the project Conclusion : As conclusion, student able to meet supervisor requirement and submit the rep

Activity : Meet and discussion session with supervisor. Objective : To ask opinion from supervisor. Content/Procedure : 1) Student meet with supervisor at the office and discussion session was conducted. 2) Jot down important notes. Result & Analysis :  1) Student discuss with supervisor to ask for guide and opinion for draft for FYP 1 report. From that discussion, student need to include several missing subtopic in the report. Below is the outcome from the discussion session :  Need to revise the chapter 2 of the report which is the literature review. Need to add up to 4 or 5 literature sources such as articles, journal or books. Need to add schematic diagram, list of components price and Gantt chart inside chapter 3 of the report. 2) Besides, supervisor also ask student to settle up the FYP blog which later need to be print and send it to her. 3) Student need to submit FYP 1 draft later. Co

Activity : Proceed with chapter 3 for FYP 1 report. Objective : Help student to complete their FYP 1 report before the deadline. Content/Procedure :  1) Firstly, student need to make some research for chapter 3 which is Methodology. 2) Student can refer to previous presentation slide or other reliable source. Result & Analysis :  1) By referring to the guidelines, student knew what need to be included as subtopic inside Chapter 3. These subtopic are : Introduction Block Diagram Flowchart Hardware Software 2) Student can use previous block diagram and flowchart, but still need to make research for hardware and software. Below are the components used in this project. Arduino Mega 2560 R3 R301T Fingerprint Sensor Micro SD TF Card Adapter Module 3.5" TFT Color Display Screen Module NodeMCU ESP 8266 ESP - 12E Board Male to Female wire jumper 3) Hardware subtopic will briefly ex

Activity : Making final   reparation before presentation.  Objective : Help student ready for presentation ( FYP 1 Proposal Defence Day ) on 2 October 2019. Content/Procedure :  1) Student prepare themselves before presentation day. 2) Ask for guides, opinion and suggestion from supervisor. 3) Finishing touch up for the slides and print the slide. Result & Analysis :   1) Meeting with supervisor. Supervisor help by giving suggestion what missing input that need to be included in the slide. After the meeting, student add another input which are :  Estimated cost  Methodology ( Components used ) Slide page Methodology are included inside the slide but being hide first during presentation session. It is a preparation for Q & A session with assessors if they ask what components are used. Research for the components used and its price has been conducted. 2) Supervisor also ask student to make